Set The Instrument Nickname; Network Connection Settings - RBC Bioscience MagCore Plus II Service Manual

━ Set the Instrument Nickname

You can give the instrument an easy-to-remember
nickname for remote APP identification.
Select Setup Button
Select Unit Nickname
Select the blue square as shown in the figure
above.
Enter the name you want to give to the instrument
and then press Enter to finish adding or changing
the name.

━ Network Connection Settings

The network connection is used for the remote
monitoring APP and LIMS data transmission.
To set the remote monitoring app, you need
to first to check up with your IT staff that your
network environment has DHCP service and can
connect to the Internet and open the firewall 8083
(out), 1883 (out), 8883 (out), 80 (out) , 443 (out)
port.
When using LIMS data transfer, you need to
first establish a 21 (in) connection with the IT
staff to determine the firewall of your PC. When
transmitting as a LIMS data, we operate on the
internal network.
After setting the network environment to meet
the above rules, please insert the network route
into the network port of the instrument and boot
it.
After the connection is made, the network
will automatically assign one IP location to
the instrument. We must make sure that the
instrument is assigned to one IP
Press Setup Button
Select Network Info
Remote Monitoring APP
Server Connection Status
Please confirm the displayed TCP/IP location and
DHCP server. The same network segment is sent
to complete the network settings.
Regional Network
Connection Status