About this task
Steps
1. Place the power-button board into the slot on the palmrest.
2. Install the two (M2x2) screws to secure the power button to the palmrest.
3. Connect the power button cable to the connector on the system board.
Next steps
1. Install the
IO
board.
2. Connect the
battery
cable.
3. Install the
base
cover.
4. Install the
SD
card.
5. Follow the procedure in
System board
Removing the system board
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Remove the battery.
5. Remove the WLAN.
6. Remove the SSD.
7. Remove the memory.
8. Remove the
system
fan.
9. Remove the heatsink.
after working inside your
before working inside your computer
computer.
Disassembly and reassembly
75