Parallax QuadRover Manual page 11

6. (Optional) Install the support rod, if needed to support an antenna, flag, or similar item:
a. Using the included 1/16
image shown below.
b. Insert the support rod into the hole provided.
c. Tighten the set screw.
7. Add hydraulic oil to the hydraulic reservoir and bleed all air out of the hydraulic lines:
a. The QUADROVER must still be mounted on a stable, raised platform such that the wheels
do not contact anything.
b. Using an 11/16
of the hydraulic reservoir.
c. Insert a clean, dry funnel into the fill hole.
d. Locate the hydraulic pump under the hydraulic reservoir.
e. While continuously hand-rotating the engine clutch (connected by a belt to the hydraulic
pump) in a clockwise direction (as viewed from the rear of the QUADROVER), slowly add
10-20 multi-viscosity hydraulic oil (ISO46) to the reservoir. USE ONLY SAE/ISO
APPROVED HYDRAULIC OIL.
Copyright © Parallax Inc.
th
inch hex wrench, loosen the set screw as indicated in the
th
wrench, remove the pressure relief valve, indicated below, from the top
Propeller QUADROVER Robot (#28195) v1.3 7/8/2008 Page 11 of 16