Parallax QuadRover Manual page 13

b. Attach a cotter pin to each peg.
c. Using the mounting screws and nylon washers, in the arrangement shown, screw the
right front and back sides of the roll-cage into the QuadRover chassis.
d. Attach the metal washer and locking nuts to the right front and back sides of the roll-
cage, as shown.
e. Once the roll-cage has been mounted it should match the following image, when viewed
from below.
Copyright © Parallax Inc. Propeller QUADROVER Robot (#28195) v1.3 7/8/2008 Page 13 of 16