Advertisement
Using a screw, nylon washer, and hex nut;
connect the PING))) module to the plate. Do
not tighten the screws all the way until you
have adjusted the PING))) to make sure it is
being installed straight.
Once you have installed the PING)))
module, the plate should look similar to the
one pictured.
Step 5: Repeat (x2)
Once you have completed the first plate,
use the previous step to build the other two
plates. When you are finished with this step,
you should have 3 sensor mount plates that
look similar to those pictured.
Step 6: Sensor Mount Plate Re-Assembly
You can use the circular cutout on the top of
the Stingray to route the cables to connect
to the I/O pins.
Note: Remember which PING))) uses which
cable; the white wire of the cable will
connect to an I/O pin in step 8.
Copyright © Parallax Inc.
PING))) Kit for Stingray (#28985)
12/8/2009 Page 4 of 7
Advertisement
