Troubleshooting - Yamaha SU10 Owner's Manual

10
This chapter offers some simple advice that may help you solve problems you
experience with your SU10. If the SU10 does not seem to operate properly and
the information in this chapter does not help, please consult your Yamaha dealer
or one of the Yamaha distributors listed at the back of this manual for assistance.
Problem
PLAY
Cannot play demos
No sound

Troubleshooting

• You may have erased them. Unless you have stored
them to an external device via MIDI dump, they
are gone forever. But it is easy enough to create
your own samples and songs.
• Check the LINE OUT connection. Is the SU10 cor-
rectly connected to external powered speakers or
amp? Are the external speakers/amp switched on?
• Check the volume settings.
(a) Check sample's internally set volume (EDIT
mode; see page 44).
(b) Check the digital volume. Try pressing [+1] to
increase the level.
(c) Try adjusting the volume slider.
(d) Check the volume setting on your speakers or
amp.
• Are batteries or adaptor correctly connected? You
must use six AA batteries, or a PA-3B or PA-1B
adaptor.
• Are batteries fresh? Try again with new batteries
(alkaline batteries recommended), or check opera-
tion using a power adaptor.
• Check the Local setting in the MIDI utility. Pads
do not operate if this setting is Off. (
• Are you sure the selected pad contains sample
data?
• Check the sample's loop mode, and the start-point,
loop-point, and end-point settings.
• Are you sure the bank selection is correct? Try
playing from a different bank.
• If using FILTER or EXTERNAL FILTER: Try changing
the cutoff frequency. Certain cutoff frequencies
may cause all sound to go off.
• If using CROSSFADER or EXTERNAL mode: Check
that the Input recording parameter matches the
actual input source. (
Possible Cause
page 56)
Troubleshooting
page 57)
67