Yamaha SU10 Owner's Manual page 58

You cannot execute a split unless the following two conditions hold:
1. The destination pad is empty.
2. The End Point value of the source pad is at least 128 units less than its maximum possible
value.
Procedure
1.
When you enter this function, the LCD displays a message such as the follow-
ing:
SpltTo
x x ?
Change the destination selection as necessary. To change the bank, press [BANK].
To change to a different sample in the same bank, press the corresponding
pad, or else press [+1] or [–1].
If you do not wish to execute the split, press [>] or [<] to change to a different edit function, or
else press [EXIT] to return to PLAY mode.
2.
Press [ENTER]. The LCD displays a confirmation prompt.
Spl x x
3. Press [ENTER] to execute. If splitting is possible, the SU10 begins execution
and displays the Keep PwrOn message.
Do not switch off power while this message is on the screen.
If your destination pad is in a locked bank, the LCD briefly displays the Locked Bank!
message, then waits for another destination selection.
If the destination pad is already occupied, or if the pad's End Point is within 128 units of the
wave end, the LCD will return the Cannot Splt message and prompt you for another pad
selection. If the problem is with the End Point setting, you will not be able to execute the
split no matter which pad you choose; you must press [<] or [>] to change the edit function, or
else press [EXIT] to return to PLAY mode.
4.
Once the split is executed, the LCD asks whether to begin editing of the des-
tination pad. You can ( a ) press [ENTER] to start editing of the destination pad;
( b ) select a different sample for editing; or ( c ) press [EXIT] to return to PLAY
mode.
y y ?
51
Editing