Local Control [Local]; Ribbon Number [Rbnnum]; Initialize Note Table [Notetbinit?] - Yamaha SU10 Owner's Manual

The SU10 accepts dumps from any device, and transmits dumps to
All
Device 1.
The SU10 does not accept incoming dumps, and transmits dumps to
Off
Device 1.
Local Control
Purpose: Sets local control on or off.
Values:
On, Off
Explanation
This setting selects whether the SU10 pads control SU10 playback.
You can use both the SU10 pads and remote MIDI messages to control
On
playback.
Off Local playback is controlled exclusively by MIDI messages received from
external devices.

Ribbon Number [RbnNum]

Purpose: Assigns the ribbon's controller number.
Values:
Off, P.Bnd, 0,...,120
Explanation
This setting assigns a controller number to the ribbon, so that you can use the
ribbon to drive an external controller.
The SU10 does not output Control Change messages.
Off
When you change the ribbon value, the SU10 outputs a Pitch Bend
P.Bnd
message indicating the new value.
0,...,120 When you change the ribbon value, the SU10 outputs a MIDI Control
Change message indicating the new value. The message carries the
controller number specified by this parameter.
Initialize Note Table
Purpose
Reinitializes MIDI note-number assignments.
Procedure
Press [ENTER] to execute. The LCD will return the Init Sure? confirmation
prompt. Press [ENTER] again to proceed, or press [EXIT] to cancel and return to the
UTILITY menu level.
[Local]
[NoteTbInit?]
UTILITY Mode
57