Oven Setup - OTS PDQ Rollabout 5A Manual

CAUTION: INFRARED EMITTERS ARE
FRAGILE. HANDLE WITH CARE
11. Insert the threaded ends of the emitter into the L-Brackets in
the light panel. Holding the ceramic at the end of the emitter,
so as not to disconnect it from the glass portion of the emitter,
tighten the nuts at each end against the L-Bracket. Each emit-
ter and two L-Bracket assembly is intended to "float" to allow
for emitter expansion and contraction.
12. Reinstall the light guards.

Oven Setup

6
Remove the 3 screws
securing each light guard.
The light guards should
lightly touch the emitters
for support after tightening.