Optional Plug-In Board Installation - Yamaha S90 Owner's Manual

Optional Plug-in
Board Installation
A variety of optional Plug-in boards (page 21) sold
separately let you expand the voice library of your
instrument.
The following types of Plug-in boards can be used with
your instrument.
• PLG150-AN
• PLG150-PF
• PLG150-VL
• PLG150-DX
• PLG150-DR
• PLG150-PC
• PLG100-XG
• PLG100-VH
Installing the Plug-in Board
The S90 has three slots on the rear panel, allowing you
to install and use up to three separate Plug-in boards.
1 Turn the S90 power off, and disconnect the AC
power cord. Also, make sure to disconnect the S90
from any connected external devices.
2 Remove the large screw from the expansion bay
cover on the rear panel using a Phillips screwdriver.
Keep the removed screw in a safe place. It will be
used when attaching the cover to the S90 again.
3 GREEN
2 YELLOW
Plug-in SLOT
1 ORANGE
3 GREEN
Plug-in SLOT 2 YELLOW
1 ORANGE
124
Installing Optional Hardware
3 Remove the ribbon cables that are to be connected
to the Plug-in board from the inside of the S90. The
slots are assigned to the color-coded cables as
follows:
Slot 1 — Orange
Slot 2 — Yellow
Slot 3 — Green
Plug-in SLOT
SLOT 3
SLOT 2
SLOT 1
4 Insert the board along the guide rails, with the
connector side face up and toward you.
n The Vocal Harmony Plug-in board (PLG100-VH) can
installed only to slot 1.
n The Multi part Plug-in board (PLG-100XG) can
installed only to slot 3.
n The Single part Plug-in board can installed to any of
three slots.
Plug-in SLOT
SLOT 3
SLOT 2
SLOT 1
Securely insert the board into the
appropriate slot, taking care that the board
isn't jammed between slots.
Cable for
3 GREEN
2 YELLOW
SLOT 3
1 ORANGE
(Green)
Cable for
SLOT 2
(Yellow)
Cable for
SLOT 1
(Orange)
Green
Yellow
Orange
3 GREEN
2 YELLOW
1 ORANGE