Yamaha S90 Owner's Manual page 113

*61
Pressing the [SF5] button switches between
display of all four Parts and one single Part (in
which all receive switch settings are shown). In
the four-Part display, use the cursor buttons to
scroll.
*62
The ReceiveCh parameter in Sequence Play
mode is set in the Mixing Part Edit ([F1]
[SF2]).
*63
The BasicRcvCh parameter in Voice/
Performance Play mode is set in the Utility
mode ([F5] [SF1]).
*64
Even if the LocalCtrl is set to "off," the data
will be transmitted through the MIDI OUT
terminal. Also, the tone generator section will
respond to messages received via MIDI IN.
External MIDI Device
MIDI OUT MIDI IN
MIDI IN MIDI OUT
Tone
Keyboard
Generator
Local Off
*65
In the Master mode, you can select whether or
not to transmit MIDI messages for each zone
(Master Edit [F1] TGSwitch).
*66
Sequencer Control
off...Not transmitted/recognized.
in...Recognized but not transmitted.
out...Transmitted but not recognized.
in/out...Transmitted/recognized.
*67
MIDI IN/OUT=MIDI
SEQ KBD
To USB
From USB
Local Sw
MIDI Out
MIDI In
TG
MIDI IN/OUT=USB
SEQ KBD
To USB
From USB
Thru Port
Local Sw
MIDI Out
MIDI In
TG
*68
The "para (parallel)" parameter is not available
for the Plug-in voice.
*69
EQ (Equalizer)
EQ L/H (Low/High), Plug-in Element EQ
This is a "shelving" equalizer, which
combines separate high and low frequency
bands.
Gain
+
0
Frequency
-
High Gain
Low Gain
Low Freq High Freq
P.EQ (Parametric EQ)
The Parametric EQ is used to attenuate or
boost signal levels (gain) around the
Frequency. This type features 32 different
"Q" settings, which determine the frequency
band width of the equalizer.
+
0
Frequency
–
Freq
Q (Frequency Characteristic)
Boost6 (Boost 6dB)/Boost12 (Boost 12dB)/
Boost18 (Boost 18dB)
These can be used to boost the level of the
entire signal by 6dB, 12dB and 18dB,
respectively.
thru
If you select this, the equalizers are bypassed
and the entire signal is unaffected.
Appendix Reference
Gain
Quick Guide Basics Section