Changing The Tempo - Yamaha S08 Owner's Manual

Changing the Tempo

This determines the playback tempo for the Song at the
currently selected Chain Step. When the Song is played
back, the tempo setting made here automatically takes
precedence over the original tempo setting of the Song.
To restore the song's own playback tempo, select "***"
by entering a value less than 25.
Song1
PAGE PART ELEM KEY
❏ Settings: 25 ~ 300
1
Set the chain step by following the setting chain
procedure (steps 1 to 4).
2
Use the [ ] and [ ] buttons to call up the chain
step of which you wish to change the tempo, then
press the [ENTER] button to specify it.
3
Press the [ ] button to enter the screen for the
tempo setting.
4
Using the [DEC/NO] and [INC/YES] buttons to set
the playback tempo.
Sequence Play Job
You can two operations in th e Sequence Play Job
mode. For information on the Job table, see page 48.
InitSeq (Initialize Sequence Chain)
You can reset (initialize) all chain step settings.
SeqAll (Sequencer All Chain)
This let you automatically assign all Songs on the
highest directory of the Memory Card to each chain
step.
n Song files are assigned alphabetically according to
the file name.
1 In the Sequence Play mode, press the [JOB]
button. Job display appears.
2 Use the [
] and [
"InitSeq" or "SeqAll"
3 When you press the [ENTER] button, you will be
prompted for confirmation.
ex. Sequencer All Chain
SeqAll
PAGE PART ELEM KEY
2
52
Playing the Songs
⁄110
] buttons to select
Sure?
4 Press the [INC/YES] button to confirm.
A"Completed" message appears when the Job has
been completed, and operation returns to the
original screen. Press the [DEC/NO] button to
cancel the Job.
n For Jobs that take longer to process, you will see
the message "Executing" during processing. If you
switch off the power to the S08 while this message
is displayed, you risk corrupting your data.
5 Press the [EXIT] button to exit the Job mode.