Yamaha S08 Owner's Manual page 71

*27
Time
Depth
Deley Rate
Key on
Vib Rate
Determines the speed of pitch modulation.
Vib Depth
Determines the depth or degree of pitch
modulation.
Vib Delay
Determines the amount of time that
elapses from when a key is played to when
the Vibrato effect starts. The higher the
value, the longer the delay before the onset
of the Vibrato effect.
The settings here are offsets used to
increase and decrease the Element Pitch
LFO settings. (PAGE 35)
*28
The AC1 CC No parameter is set in the
following PAGES.
For Voice
CONTROLLER PAGE 8
For Multi (each part)
MULTI PART EDIT PAGE 19
*29
Settings:
When VarConnect is set to "INS":
on (effect is applied), off (effect is not
applied)
When VarConnect is set to "SYS":
0~127
When VarConnect is set to "INS," this
parameter determines whether or not the
Variation effect is applied to the particular
Part. In this condition, the Variation effect
cannot be used for several Parts at the
same time. Only the Part last selected will
be routed through the Variation effect.
When VarConnect is set to "SYS," this
parameter lets you adjust the send level for
the Variation effect for each Part. Also set
the related Multi Common Edit parameters
(in PAGES 16 to 21) as desired.
*30
The Rcv Ch parameter in the Multi Mode
is set in the MULTI mode (MULTI PART
EDIT PAGE 6).
*31
The data via the MIDI IN terminal is
ignored when using the USB port (Host
Select set to "USB").
*32
Even if the Local Sw is set to "off," the
data will be transmitted through the MIDI
OUT terminal. Also, the tone generator
section will respond to messages received
via MIDI IN.
External MIDI Device
MIDI OUT MIDI IN
MIDI IN MIDI OUT
Tone
Keyboard
Generator
Local Off
*33
For details about Control Numbers and
Control Change messages, see page 72 and
the separate Data List.
Appendix Reference Quick Guide Basics Section