Multi Job - Yamaha S08 Owner's Manual

Selected Selected
Display
by by
13 -1 PEGIntL Pitch EG Initial Level
13 -2 PEGAtkTm Pitch EG Attack Time
13 -3 PEGRelL Pitch EG Release Level
13 -4 PEGRelTm Pitch EG Release Time
14 -1 Vib Rate Vibrato Rate
14 -2 Vib Depth Vibrato Depth
14 -3 Vib Delay Vibrato Delay Time
CONTROLLER
15 -1 Porta Sw Portamento Switch
15 -2 PortaTime Portamento Time
16 PB Range Pitch Bend Range
17 MW FltCtl MW Filter Control
18 -1 MW PMod MW LFO Pitch Modulation Depth
18 -2 MW FMod MW LFO Filter Modulation Depth
18 -3 MW AMod MW LFO Amplitude Modulation Depth
19 AC1 CC No Multi Mode AC1 Control Number
20 AC1FltCtl AC1 Low Pass Filter Control
21 -1 AC1 FMod AC1 LFO Filter Modulation Depth
21 -2 AC1 AMod AC1 LFO Amplitude Modulation Depth
EFFECT
22 ReverbSend Reverb Send
23 ChorusSend Chorus Send
24 Var Send Variation Send
■ Multi Job [MULTI] → → → → Multi Selection → → → → [JOB]
1 Init Initialize
2 CpyVar Copy Variation Effect
3 CpyCtl Copy Controller
4 CpyPart Copy Part
5 BlkDmp Bulk Dump
Parameter Name
Controls how the pitch changes from the moment a note is pressed on the keyboard to the moment it is
released or the point at which the level has faded to zero.
.
Determines the speed of pitch modulation.
Determines the depth or degree of pitch modulation.
Determines the delay time before the Vibrato comes into effect.
Determines whether Portamento (a smooth transition in pitch from one note to the next) is on or off.
Determines the pitch transition time for Portamento. Higher values result in longer transition times.
Determines the amount (in semitones; 12: one octave) by which the pitch is varied when you move the
Pitch Bend wheel up/down.
Determines the depth of the MW (Modulation Wheel) over the filter cutoff frequency.
Determines the depth of control the Modulation Wheel has over pitch modulation (vibrato effect).
Determines the depth of control the Modulation Wheel has over filter cutoff modulation (wah effect).
Determines the depth of control the Modulation Wheel has over amplitude modulation (tremolo effect).
Determines the Control number for the AC1 of each Part.
Determines the depth of the AC1 (Assignable Controller 1) over the filter cutoff frequency.
Determines the depth of control the AC1 has over filter cutoff modulation (wah effect).
Determines the depth of control the AC1 has over amplitude modulation (tremolo effect).
Determines the send level of the Reverb Effect.
Determines the send level of the Chorus Effect.
Determines the send level of the Variation Effect.
Resets (initializes) all parameters of a Multi to their default settings. Use the [DEC/NO] and [INC/YES]
buttons to select the parameter type to be initialized.
Copies Effect settings of the Voice to Multi.
Copies the Controller settings for the Voice assigned to the Part.
Copies Part parameter settings of the Multi being edited to another Part in the same Multi.
Sends your edited Multi data to a computer or another MIDI device for data archivung.
Explanation
Appendix Reference
Related
Page
*26
*27
*27
*27
22
22
37
47 *3
47
47 *29
48
48
48
48
36, 49
Multi Edit Part / Multi Job
Quick Guide Basics Section