Yamaha S08 Owner's Manual page 64

Selected Selected
Display
by by
SndVar → Rev
18 Send Variation To Reverb
SndVar → Cho
19 Send Variation To Chorus
20 MW VarCtl MW Variation Control Depth
21 AC1VarCtl AC1 Variation Control Depth
Part...Settings of individual 16 parts
[MULTI] → → → → Multi Selection → → → → [EDIT] → → → → [+] or [-]
VOICE
1 Voice Bank Select MSB/LSB, Program Number
Selection
MIX
2 Volume Volume
3 Pan Pan
4 -1/-2 NtLmt-L/H Note Limit Low/High
5 -1/-2 VelLmt-L/H Velocity Limit Low/High
GENERAL
6 Rcv Ch MIDI Receive Channel
7 -1/-2 NoteShift/ Note Shift/Detune
Detune
8 Mono/Poly Mono/Poly
9 Part Mode Part Mode
TONE
10 -1 VelSnsDpt Velocity Sensitivity Depth
-2 VelSnsOfs Velocity Sensitivity Offset
11 -1 Cutoff Filter Cutoff Frequency
-2 Resonance Filter Resonance
12 -1 Attack Tm Attack Time
-2 Decay Tm Decay Time
-3 Releas Tm Release Time
Parameter Name
Determines the send level of the signal sent from the Variation Effect to the Reverb Effect.
Determines the send level of the signal sent from the Variation Effect to the Chorus Effect.
Each Variation Effect type has a specific fixed parameter that can be controlled in realtime with the MW
or AC1. (Refer to the Effect Parameter List in the separate Data List.)
Assigns a Voice to each Part.
Adjusts the output level of each Part.
Determines the Stereo Pan position. (Rnd: Pan position moves randomly each time a key is played)
Determines the lowest and highest notes of the keyboard range.
Determines the minimum and maximum values of the velocity range within which each Part will respond.
Each Part receives MIDI messages according to the channel set here. Select "off" for Parts that you do not
want to respond to MIDI.
For Note Shift: Determines the pitch (key transpose) setting in semitones (12: one octave). For Detune:
Determines the fine tuning.
Selects whether each part is played back monophonically (single notes only) or polyphonically (multiple
simultaneous notes).
Determines whether the Part uses Normal Voices (norm) or Drum Voices (drum).
Determines the velocity sensitivity , or how much the level of the voice changes in response to your
playing strength (velocity).
Determines the amount by which received velocities are adjusted for the actual velocity effect.
Determines the cutoff frequency for the low pass filter.
Determines the amount of filter resonance or emphasis of the Cutoff Frequency.
Controls how the tone (filter) or volume (amplitude) changes from the moment a note is pressed on the
keyboard to the moment it is released, or the point at which the level has faded to zero.
Appendix Reference
Explanation
Guide Quick Section
Multi Edit Common / Part
Related
Page
47
47
37
37
Settings...MIDI Data Table 2-8 in the separate Data List
31
44
28
28
42
28
22
22
39
39
43
43
Basics
*20
*20
*21
*22
*23
*24
*1
*25