Checking Hardware Installation; Checking Cable Connections - Huawei OceanStor Dorado5100 Quick Installation Manual

Checking Hardware Installation

1
Checking Device Installation
Check Item
Controller enclosure
Disk enclosure
2

Checking Cable Connections

Check Item
Ground cable
Optical transceiver
Optical fibre
mini SAS cable
Network cable
AC power cable
Normal
 The device sits stably on the guide rails
without any displacement.
 Screws are fixed properly.
Normal
The ground cable is properly fixed to the
ground terminal.
 The optical transceiver is fully inserted
into the FC port.
 The buckle is locked.
The optical fibre is fully inserted into the
optical transceiver.
The buckle of optical fibre connector
tightly locks the optical transceiver.
 Each mini SAS cable connects to an
EXP expansion port and a PRI expansion
port.
 Each mini SAS cable is fully inserted in
the expansion ports that it connects.
The network cable is fully inserted into the
management network port.
The AC power cables for each controller
enclosure or disk enclosure are connected
to two separate power sources redundantly.
12
Abnormal
 The device slants.
 Screws are loose or fall off.
Abnormal
The ground cable is loose or falls off.
 The optical transceiver is loose in the FC
port.
 The buckle is loose.
 The optical fibre is loose in the optical
transceiver.
The buckle of optical fibre connector does
not properly lock the optical transceiver.
 The mini SAS cable connects to two EXP
expansion ports or two PRI expansion
ports.
 The mini SAS cable is loose in the
expansion ports that it connects.
The network cable is loose in the
management network port.
The AC power cables for each controller
enclosure or disk enclosure are connected to
the same power source.