Advertisement
Step 4:
Turn the pedestal assembly over and slide the leg extenders item 2 into the pedestal tube making
sure the plastic insert in the end of the leg extender is exposed. Align the threads of the leg
extender with the holes in the pedestal tube and select the desired height of the bench. Thread
the 1/4-20 x .75 hex head bolts item A with the 1/4 flat washers item D into the threaded holes in
the leg extender and tighten. Thread the floor glide item F into the plastic insert of the leg
extender. The floor glides are used to level the bench when assembly is complete and it is put
into position.
Step 5:
If the leg assembly is to be installed to a worksurface with a single WSC cabinet, install it and the
WSC by installing it with the worksurface face down. Once installed and using more than two
persons, turn the WSC and pedestal assembly over and add the drawers.
If the leg assembly is to be installed to a worksurface with more than one WSC cabinet it is
recommended that only the leg assembly be install to the worksurface in the face down position,
then turned over and install the worksurface and leg assembly to the WSC cabinets.
Install leg assembly to worksurface using #14 X 1.00 screw item C and 1/4 flat washers item D as
shown below.
8
Advertisement
