Advertisement
When installing more than one WSC cabinet it is recommended that the WSC cabinets not be
installed in the upside down position with the worksurface face down due to the weight of more
than one WSC cabinet. Note: If a WSC Leg Assembly was purchase see pages 7 and 8 before
installing WSC cabinets.
Step 3:
Install the WSC cabinets by placing them side by side in the position / orientation in which you
choose. Remove two or three of the cabinet drawers as shown below to allow access to the holes
on the top of the WSC cabinets. Remove drawers by pulling it out of the WSC cabinet enough to
locate the two small plastic tabs on the drawer slides. Push the right tab DOWN and the pull left
tab UP and pull the drawer body out of the drawer slides.
Step 4:
Place the worksurface on top of the WSC cabinets, aligning it to the pre-drill holes in the
underside of the worksurface and using set of #14AB X 1.00 screws items B and 1/4 Flat
Washers item C install the worksurface to the WSC cabinets. Do not over tighten hardware.
4
Advertisement
