Yamaha N-100 Owner's Manual page 28

Keyboard Stand Assembly
2-3
While supporting B with your hand, pass the
pedal cord (attached to C) through from the
inside to the outside of B.
Position C upside down, then insert it into the
slot on B. Be sure to push C until it stops.
2-4
While holding and pressing C securely into the
slot, fix it to B using four long screws (6x20mm).
2-5
Turn B so that its bottom side of (the side on
which C is attached) is on the floor.
2-6
Pass the pedal cord and power cord into the
groove on B, then attach them to the top of B
using the four vinyl ties.
Be sure to have the end of the power cord extend
past the top edge of B by 20cm or more (roughly
half the length of B).
20cm
28
N-100 Owner's Manual
B B
C C
B B
C C
B B
At least 20cm
B
2-7
Replace the plastic cover onto the groove of B.
Do not insert the feet of the groove cover between
the groove socket and groove wall.
B
3.
Fix B to A.
3-1
Place B in front of A, with the speaker net on B
facing upward.
3-2
Insert the speaker cord plug into the connector on
the bottom surface of A, with the plug's tab facing
to the rear.
A
B B
Correct
Incorrect