Recharging The Battery - KTM Freeride 250 R 2017 Setup Instructions

3 SERVICE WORK ON THE CHASSIS
3.10 Checking the throttle cable routing
3.11

Recharging the battery

Warning
Risk of injury Batteries contain harmful substances.
–
Keep batteries out of the reach of children.
–
Keep sparks and open flames away from the batteries.
–
Only charge batteries in well-ventilated rooms.
–
Maintain a minimum clearance from inflammable materials when charging batteries.
Minimum clearance
–
Do not charge deeply discharged batteries if charge is already below the minimum voltage.
Minimum voltage before the start of the charge
–
Dispose of batteries with less than the minimum voltage correctly.
Warning
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
–
Mount and tighten screws
Guideline
Screw, fuel tank
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Mount the fuel tank breather hose.
C00906-11
Finishing work
–
Lock the seat. (
Preparatory work
–
Fold the seat up. (
–
Remove the fuel tank. (
Main work
–
Check the throttle cable routing.
The throttle cable must be routed to the carburetor along the back of the handle-
bar, below the seat fixing.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
F00183-01
Finishing work
–
Install the fuel tank. (
–
Lock the seat. (

on both sides.
M8

.
M6
p. 10)
p. 10)
p. 10)
p. 11)
p. 10)
1 m (3 ft)
9 V
15 Nm Loctite ® 243™
(11.1 lbf ft)
10 Nm (7.4 lbf ft)
12