Yamaha MagicStomp Owner's Manual page 16

3 "Editor Setup" button
Click this to open the "Setup" dialog and specify the MIDI port settings.
"Setup" Dialog
These settings let you transmit and receive patch data between the MAGICSTOMP and the
computer.
Click the [OK] button to apply the settings and quit the dialog. Click the [Cancel] button to
quit without applying the settings.
* Bulk Transmit: Data in the computer is transmitted to the MAGICSTOMP.
* Bulk Receive: Data in the MAGICSTOMP is downloaded into the computer.
Windows
1
2
3
4
5
6
1 MIDI In Port: ...........Click this and choose the MIDI In port. You can use the Sound Editor
n
If you are using a Macintosh, the MIDI In Port setting is assigned in the OMS Port Setup.
2 MIDI Out Port: ........Click this and choose the MIDI Out port. You can use the Sound
n
If you are using a Macintosh, the MIDI Out Port setting is assigned in the OMS Port Setup.
11).
3 MIDI Ch: ..................Sets the MIDI transmit/receive channels for transferring data between
4 Device No.: .............This number is used when transmitting/receiving system exclusive
5 Dump Interval: .......Click this and choose the interval between successive MIDI dumps.
n
If errors occur while transferring data, set this value to a higher number.
6 Export to Host: ......This function is not available with the MAGICSTOMP.
to receive data sent from the MAGICSTOMP connected to this port.
Editor to control and edit the MAGICSTOMP connected to this port.
the MAGICSTOMP and the computer.
Set the MAGICSTOMP to "1".
data (bulk transmit/receive).
Set the MAGICSTOMP to "1".
Macintosh
16
3
4
5
(page 11).
(page