Yamaha Electone EL-100 Owner's Manual page 20

Use the top left side Data Control button pair to change the level of the
desired voice. Fine volume settings, 0-24, are available.
DATA CONTROL
2
5
Now select voices for the Lower keyboard and Pedalboard as you did
for the Upper keyboard above. Also set the volumes of the voices.
6
Adjust the volume balance between the Upper and Lower Voices with
the Balance Control provided on the Voice Display.
To adjust the volume balance:
1. Press the VOICE DISPLAY button in the DISPLAY SELECT
section. The Voice Display always appears when the Electone is
turned on.
2. Select page 2 of the Voice Display using Page buttons at the right
side of the LCD display.
DATA CONTROL
3. Adjust the balance with the corresponding Data Control buttons, at
the top right side. The positive values increase the Upper Keyboard
volume, while the negative values lower it, or increase the Lower
Keyboard volume. Range: -6 - +6
DATA CONTROL
20
VOL.:24 PAN:C
REVERB:24
DISPLAY SELECT
VOICE EFFECT A.B.C.
DISPLAY SET M.O.C.
FOOT REGIST. PITCH TREMOLO
SW. SHIFT MIDI
¨⁄Strings1ÎViolin1 ⁄
Ò⁄Strings1∏⁄ContBs.1
¨¤Strings1 M.BAL:+4¤
Ò¤Strings1∏¤ContBs.1
DATA CONTROL
¨1¤
(FAST)
DATA CONTROL
DATA CONTROL
NOTE:
Pressing a voice button once calls up that
voice's Voice Menu display. Pressing it a
second time calls up the Voice Condition
display. Successive presses alternate
between the two displays.
NOTE:
The Lead and Pedal Voices sound one note
at a time; when you simultaneously press
two or more keys, only the highest note
will sound.
PAGE
NOTE:
Pressing this pair of Data Control buttons
at the same time restores the balance to the
center position.