OH85N-DJ
1
Distribution
switchboard
2
3
Make sure that you have a 8.5 mm diameter
waterproof power cable that can withstand 1800 W or
higher.
" The power cables from the main display (
auxiliary display (
) should be connected to 40 A (20 A x 2)
or higher amperage circuits.
Connect the two power cables to each other. Solder
and insulate the connected part.
Put the soldered (connected) part of the power cables
inside the product.
4
) and the
5
Once all cables are connected, place the bracket PCB
( ) back to the bottom of the main display ( ).
Close the auxiliary display ( ) completely, then fasten
the brackets on both sides of the product.
13