Yamaha CS1X Owner's Manual page 24

To start the Arpeggiator, press the ARPEGGIATOR button to turn it
on. A [ ] mark will appear in the LCD above the word
"ARPEGGIATOR".
NOTE
To turn the Arpeggiator off, press the ARPEGGIATOR button
again.
TYPE: Sets the type of arpeggio. You can choose from 30 types.
For details about each type, see the Arpeggiator Type List in the
"Data List" book.
Arpeggiator Hold
The Arpeggiator Hold function lets you play a chord to start the
automatic arpeggio, then take your hand off the keyboard; the
arpeggiated chord will play continuously in a loop. Play another
chord and the automatic arpeggios will change accordingly.
To activate the Arpeggiator Hold function, perform the following:
1. Hold SHIFT and press ARPEGGIATOR. The Arpeggiator indicator in
the LCD will start blinking.
2.Play a series of chords.
3.To stop the arpeggiated chords, press ARPEGGIATOR again.
Arpeggiator Split
If you hold SHIFT and press the Parameter Value [UP] button when
the TYPE parameter is displayed in the LCD, the Arpeggiator Split
function will be enabled, and a reversed type letter "S" will appear
to the right of the Arpeggiator type.
The Split function splits the keyboard from C3 (indicated above the
keyboard with [ ]) and will allow you to play the arpeggiated chords
on the lower half (below C3) of the keyboard, and play a melody line on
the upper half (C3 and above).
To cancel the Split function, hold SHIFT and press the Parameter
Value [DOWN] button.
TEMPO: Sets the tempo of the Arpeggiator. The range is MIDI, 40
~ 240.
Settings:
TEMPO: MIDI, 40 ~ 240 (beats per minute)
NOTE
If you want to synchronize the tempo of the Arpeggiator
with that of an external MIDI device, set the TEMPO parameter to MIDI.
SUBDIVIDE: Determines the basic note settings (how fine the
tempo is divided) of the Arpeggiator.
Settings:
SUBDIVIDE: 3/8= , 1/4= , 3/16=
1/12= , 1/16= , 1/24= , 1/32=
NOTE
The Arpeggiator data cannot be output as the MIDI messages.
, 1/6= , 1/8= , 3/32= ,
23
PERFORM LEVEL
This sets the volume of each Performance.
Settings:
PERFORM LEVEL (Performance Level): 0~127
EFFECT
There are five effect parameters: REV TYPE (Reverb Type), CHO
TYPE (Chorus Type), VARI TYPE (Variation Type), VARI PARAM
(Variation Parameter) and VARI DATA (Variation Data).
For more basic information on each effect, see page 47.
Reverb Type Chorus Type
Variation Type Variation Parameter
Variation Data
REV TYPE (Reverb Type): Sets the Reverb type. You can choose
from 11 types. For more information about each Reverb type, see
Effect Type List on page 49.
CHO TYPE (Chorus Type): Sets the Chorus type. You can choose
from 11 types. For more information about each Chorus type, see
Effect Type List on page 49.
VARI TYPE (Variation Type): Sets the Variation effect type. There are
43 types to choose from. For more information about each Variation
effect type, see Effect Type List on page 49.
VARI PARAM (Variation Parameter): Selects the Variation effect
parameters. Parameters will differ depending on the Variation
effect type selected in VARI TYPE.
The letter "P" (Parameter) or "d"
(Data) displays to distinguish
between the Variation Parameter
and Variation Data screens.