How to Program Buttons
Use programming to store dialing sequences on programmable buttons (see
diagram, panels 2–3). Then simply touch the button to dial automatically.
1.
Press [
] [
] [
Feature
0
0
2.
Press a programmable button.
3.
Press the buttons you normally press to dial another extension, to dial an
outside telephone number, or to use a system feature (see examples below).
NOTE: To store [
Intercom
To program more buttons, or to change the programming, repeat steps 2 and 3.
Press [
] [
] [
4.
Feature
0
0
Examples:
Another extension number
To ring extension 11 with one touch, program [
extension 11, program [
You can also use this button to:
Transfer calls with one touch.
See when the extension is busy (red steady light) or calling you (green flashing
light), or when a transferred call is returning to you (green fluttering light).
An outside telephone number
To dial 555-5678 with one touch, program [
Any dial-code feature on panel 5 or 6
Program the dial code on a button. For example, to use Do Not Disturb with one
touch, program [
] [
Feature
must also program an extension number or group number (but not a line number),
as indicated in the feature description on panels 5 and 6. For example, to answer a
call ringing at extension 12, program [
How to Program Personal Speed Dial
Numbers
1.
Press [
] [
] [
Feature
0
0
2.
Press [
], then the two-digit Dial Code (80–99) for the phone number.
Feature
3.
Enter the phone number. (An outside number can have up to 20 digits.)
To add more numbers, repeat steps 2 and 3.
4.
Press [
] [
] [
Feature
0
0
To change a number, follow steps 1–4 but enter the new number in
Special Dialing Functions
You can enter the following special functions in Speed Dial or Auto Dial numbers:
Function
Button Display Description
Pause
[
Hold
Recall
[
Spkr
Stop
[
Mic
Touch-Tone Enable
[
Transfer
Programming
] to enter program mode.
] on a button, press the left [
] to exit program mode.
Intercom
] [ ] [
] [
].
Intercom
1
1
] [
5
5
] [
] on a button with lights. For some features, you
0
1
] [
Intercom
6
] to enter program mode.
] to exit program mode.
P
1.5-second pause
]
R
Timed switchhook flash
]
Stops dialing sequence until button is
S
]
pressed or code is dialed again
] T
Sends touch tones over a rotary line
4
] button.
Intercom
] [
] [
] to voice signal
1
1
] [
] [
] [
] [
] [
].
5
5
6
7
8
] [
] [
] on a button.
1
2
tep 3.
S
Need help?
Do you have a question about the MLS-34D and is the answer not in the manual?