Grease Filters - Atag CU1050SMR Instructions For Use Manual

MAINTENANCE
Grease filter
PUSH
PUSH
PUSH
PUSH
EN 10
Removing cassette filter
1. Switch off the motor and lighting.
2. Push in the latches and open the panel.
3. Open the filter's access latch. Support the filter with your hand.
4. Remove the filter from the built in unit.
Cleaning
The filters can be cleaned in the dishwasher. Allow the filters to drain
well before replacing.
The filters can also be cleaned by hand.
Clean the filters in soapy water with washing up liquid and rinse. Allow
the filters to drain well. See page 9 for instructions. The underside of
the built in unit can be cleaned with a mild cleaning agent and a damp
cloth. Dry off with a paper towel.
Replacing cassette filter
The filter should be placed with the locking mechanism on the front.
Open the filter access latch. The notches at the front of the filter will
then slot in. Hold the access latch in this position when placing the
filters.
1. Slot the notches at the back of the filter in the specially designed
opening of the built in unit.
2. Tilt the filter upwards.
3. Release the filter access hatch. The notches at the back of the filter
will extend outwards and slot into the specially designed openings
of the built in unit. The filter is now in position again.
4. Press the edge extraction panel firmly in the seal again (you will
hear a click).
It is important that the grease filters are thoroughly dry before
repositioning.