Atag CU1050SMR Instructions For Use Manual page 37

USE
▷ At lowest dimmer setting the light will go back from dimmed light
to brighter light.
If you have used the dimmer function and then switch off the lighting,
the last dimming setting will be used when the lighting is switched on
again.
Setting the lighting color
1. Switch On the light.
2. Press and hold the 'Off / clean air button'.
▷ The lightcolor will switch to the 'coldest' setting and will become
'warmer' the longer you depress the switch.
▷ At the 'warmest' setting the light color will go back to a 'colder'
light color.
▷ The selected light color will remain in the built in units memory.
Switching On the timer
1. Choose the fan setting desired and press the timer button.
▷ The extractor remains at the selected setting for 10 minutes,
after which the extractor is automatically switched Off.
▷ Timer indication appears on the led status bar.
Clean air function
1. Switch Off the built in unit and lighting.
2. Select within 5 seconds the desired speed for the clean air function
by pressing the '+' or '-' buttons and press the clean air button to
confirm.
▷ The Clean air function is activated.
▷ The clean air indication appears on the led status bar.
▷ The built in unit will be switched on for 10 minutes every hour at
the selected level.
3. Select if desired a different speed setting.
4. Switch Off the clean air function by pressing the '+' or '-' buttons.
Filter saturation signal
• Filter saturation indication appears on the led status bar:
▷ Clean the metal grease filters
• Six consecutive audible signals:
▷ Replace the carbon filters.
EN 7