Clp-240/230: Keyboard Stand Assembly - Yamaha Clavinova CLP-230 Owner's Manual

CLP-240/230: Keyboard Stand Assembly

CAUTION
• Be careful not to confuse parts, and be sure to install all parts in the correct direction. Please assemble the unit
in the appropriate sequence.
• Assembly should be carried out by at least two persons.
• Be sure to use the correct screw size. Using of incorrect screws can cause damage.
• Be sure to tighten all screws upon completing assembly of each unit.
• To disassemble, reverse the assembly sequence.
Have a Phillips-head (+) screwdriver ready.
Remove all parts from the box. Confirm that all parts shown in the illustration are provided.
A
Styrofoam pads
Take out the styrofoam pads, and place A on top of the pads.
Position the styrofoam pads to protect the connector panel at
the bottom of A.
B
Bundled pedal cord inside
C
D
1.
Attach D and E to C.
1-1
1-2
6 x 25 mm long screws x 4
6 x 16 mm short screws x 4
4 x 12 mm thin screws x 2
4 x 20 mm tapping screws x 4
4 x 10 mm thin screws x2
Cord holders x 2
E
1-1
1-2

CLP-240/230: Keyboard Stand Assembly

AC power cord
(The shape of plug differs
depending on locale)
Headphone hanger
Side panel protection
(cardboard) pads x 2
Untie and straighten out the bundled cord. Don't
discard the twist tie, you'll need it later in step 5.
Secure C using the four 6 x 25 mm long screws.
CLP-240/230 Owner's Manual
65