2
B
B
It is not necessary to perform this procedure on the CLP-880PE.
X
millimeter long gold-colored screws 1 (3 each).
cutouts. If the feet have cutouts, make sure that the cutouts on the
feet face the bracket side of the side panels.
C
bundled cord attached to the bottom of the pedal box.
panels (B), and attach using the four 6 x 20 millimeter round-head
screws 2 — two screws on each side. Make sure the pedals extend
in the same direction as the feet.
If applicable, align the
cut corner of the bracket
with the corresponding
cutouts on the feet.
1
5 x 40 mm long gold screws
Assemble the side panels (B) and feet (C).
Secure the feet (C) to the side panels (B) with the 5 x 40
Depending on the unit type, the feet (C) may or may not have
It is not necessary to perform this procedure on the CLP-880PE.
Attach the side panels (B) to the pedal box
(D).
Before installing the pedal box, untie and straighten out the
Place the pedal box on top of the brackets attached to the side
3
6 x 20 mm round-head screws
B
2
B
D
CLP-880/860/840/820/820S
49