Display Of Print Counter, And Reset Of Print Counter - Mitsubishi Thermal Digiplater User Manual

3.3.6

Display of Print Counter, and Reset of Print Counter

Display of print counter and reset of print counter are executed as follows.
When reset is executed, print counter is「0」, and the number of the printed plates is added
until reset is executed next time.
1.
In the ready state, press the menu button
once, press the + button 5 times, and
display "Counter" on the LCD.
2.
Press the enter button, and display the print
counter.
3.
Press the enter button to come to the state
which can reset print counter.
4.
Press the enter button to reset print counter.
※．Press the clear button when not resetting.
5.
Press the clear button repeatedly until the
ready state is displayed.
[Useful tip]
Pressing the + or - button repeatedly changes the message on the LCD as
shown below.
［Plate Size］ ［Size Set］
［Remains Sw］ ［Platen Cleaning］
Chapter 3
Counter
［Density］
［Firmware Version］
［Manage Count］
LCD message cycle when［+］is pressed repeatedly
LCD message cycle when［-］is pressed repeatedly
Counter □□□□
Reset?
Counter
-35-
Use of Operation Panel
［Plate］
［Counter］
［Interval Set］ ［Adjust Plate］
0