Chapter 2
Installation and Setup
2.8 Setting the plate
1.
Turn on the power to the THERMAL
DIGIPLATER.
2.
Set the size of the plate to be installed on the operation panel.
See 3.3.1 Selecting the plate size.
3.
By holding the opening lever B, open the
plate cover.
Do not open the plate cover extremely
quickly or forcibly 90 degrees or more.
4.
When there is any used plate, pull out the
lead edge of the plate and lift up the plate
with the spool, and take it out.
The plate weighs approx. 10 kg(22 lbs).
Handle it carefully so as not to drop it.
Dropping it is dangerous.
Power switch
Plate roll
-16-
Opening lever B
Plate cover