Table of Contents
Advertisement
Available languages
Available languages
Transmitter
On / Off indicator LED
Up / down
Tri-band channel
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1.- Open the battery cover.
2.- Fit the batteries (respect polarity).
3.- Close battery cover.
Helicopter:
Switch in position OFF.
1.- Open the charger cable cover.
2.- Connect the cable between the transmitter and the helicopter.
3.- Switch ON the transmitter.
4.- Green and red LEDS will turn on. When the process finishes the green LED will turn off. (charging time approx. 30 min).
5.- Disconnect the plug. The flying time is 5-9 min.
6.- It is also possible to charge the helicopter directly from a computer with the same USB charger cable.
HELICOPTER FLIGHT
1.- Select the band in the transmitter A, B o C and the helicopter will automatically identify it.
2.- With the helicopter switched off, first switch on the transmitter.
3.- Switch on the helicopter.
4.- Place the helicopter in the floor..
Trim adjustments:
1.- Push the left stick to synchronize the helicopter with the transmitter.
2.- Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
3.- If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it clockwise o vice versa until the helicopter stops turning.
Charge indicator LED
Turn right / left
Forward / backward
Imported and distributed by:
NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincohobby.com
EC-135 – PALM G – ALUG G
(3 channels)
Trim
On / Off / Charge
Advertisement
Table of Contents
