Technical Data - VOLTCRAFT LZG-1 Operating Instructions Manual

Please always observe the safety instructions!
Error
The device
does not work.
None change of the
measuring value.
Repairs other than those described should only be carried out by an authorised
specialist. If you have queries about handling the measuring device, our technical
support is available under the following telephone number:
Voltcraft®, 92242 Hirschau, Lindenweg 15, Tel.-No. 0180 / 586,582 7.

TECHNICAL DATA

Display
Measuring cable length
Measuring impedance
Automatic switch-off
Operating voltage
Working conditions
Operating altitude
Storage temperature
Weight
Dimensions (LxWxH)
Over-voltage category
Line allocation
Conductor resistance
Polarity test
Continuity tester
Measuring cable length
Overload protection
36
Possible cause
Is the battery dead?
Is a wrong measuring function
activated (AC/DC)?
Is the HOLD function activated?
(display "HOLD")
LCD; 2000 counts
about 80 cm each
>7.5 MΩ (V range)
approx. 15 minutes
DMM
Receiver
Transmitter 9V block battery
0 to 40°C (<75%rh)
max. 2,000 m
-10°C to +50°C (<80%rh)
DMM
Transmitter ca. 230 g
DMM
Transmitter 140 x 69 x 32 (mm)
CAT III 600 V, contamination degree 2
(only DMM via safety sockets)
max. 30 kΩ (for test length)
5 – 16 V/DC
<100 Ω (acoustic)
about 27 cm each
max. 50 V
Remedy
Check the status.
Battery replacement
Check the display (AC/DC) and
switch the function if applicable.
Press the key "HOLD" to
deactivate this function.
2 x micro batteries (AAA)
9V block battery
ca. 308 g
162 x 74 x 44 (mm)