Operating Elements - VOLTCRAFT LZG-1 Operating Instructions Manual

OPERATING ELEMENTS

(see fold-out page)
1 Display (LED) for cable allocation, continuity tester and polarity test
2 Toggle key continuity tester and cable allocation (R = receiver)
3 Toggle key cable allocation (R = receiver) and polarity test (V check)
4 Rotary switch
5 Display (LCD) for multimeter
6 MODE button for switching the measuring functions diode test and continuity tester
7 COM measuring socket (reference mass, minus potential)
8 V measuring sockets for all measuring functions of the multimeter (plus potential)
9 HOLD button for "freezing" the display value
10 MAX button; records the maximum value in the voltage measuring range.
11 Battery compartment on the rear
12 Removable protective rubber frame with setup brackets on the rear
13 ON/OFF button for activating/deactivating the cable allocation display
14 Measuring leads for cable allocation and polarity test (red = positive pole, black = reference
potential))
15 Battery compartment at rear
16 Duty switch for remote unit (depressed = on)
17 Operating indicator "OP"
18 Battery change indicator "LO BAT"
19 Identification lines (black = G (reference lines), red = code 1 – 16)
23