Early Childhood Resources ELR-0633 Manual

5-Section Coat Locker
without Bench
Model # ELR-0633
Mount Laurel,NJ 08054 USA
www.ecr4kids.com
TIGHTEN SCREWS
B
UNTIL ALL SCREWS
HAVE BEEN LOOSELY
C
A2
F
F
F
A1
F
G
G
E
G
G
A2
A1 BEFORE ASSEMBLING,
Left Side Panel
MAKE SURE THERE
A2
Right Side Panel
B
Top Shelf
C
Upper Center Shelf
D
Lower Center Shelf
!
E
Bottom Shelf
F
Upper Divider(4)
G
Lower Divider(4)
- Adult Assembly Required. Two
H
Lower Back
adults recommended.
I
Upper Back(5)
- Contains small parts, sharp points
J
Metal Dowels(16)
and edges.
K
Round Hex Head
Screw(24)
- Do not stand, sit, kneel, climb, lean
L
Flat Hex Head
or pull on unit for support.
Screw(8)
- Never leave children unattended.
M
Hex Key Tool
- Do not place unit near high heat or
N
Hooks(10)
moisture.
- Adult Supervision Recommended.
O
Posts(12)
P
Post Screws(12)
Q
Cams(16)
NOTE:
A Phillips Head Screwdriver
will be needed for
assembly (not included)
1
TIP！
DO NOT FULLY
POSITIONED。
B
I
I
1A. Attach 4 Lower Dividers(G) to the Base(E) using 8 Round Hex Head
I
Screws(K), using 2 in each. Tighten with the Hex Key Tool(L).
I
2 Attach the Upper Dividers to the
I
Lower Center Shelf
H
ARE NO
MISSING PARTS.
WARNING:
2A. Two Adults Suggested: On a carpet, or protected surface, attach
Upper Dividers(F) to the Lower Center Shelf(D) using 8 Flat Hex-Head
Screws(L), using 2 in each. Tighten with the Hex Key Tool(M).
2B. Insert 8 Metal Dowels(J) into the plastic plugs located underneath
Lower Center Shelf(D). Tighten with a Phillips Head Screwdriver.
3
3A. Lay the assembled Base(E,G) on its back, facing upward. Insert 8
Cams(Q) into the large holes located in the 4 Lower Dividers(G), using 2
in each. Make sure the arrows on Cams(Q) point toward the holes in the
closest ends.
3B. Two Adults Suggested: Position the assembled Upper Section(D,F)
so the Metal Dowels(J) attached to Lower Center Shelf(D) enter the holes
in the top edges of the Lower Dividers(G) as shown.
Attach Lower Dividers to
Bottom Panel
G
G
G
G
E
X8
Q
X8 X8
L
Attach the Top Section to the
Bottom Section
F
F
F
F
X8
K
4
Attach the Upper Center Shelf
and Back Panels
J
F
I
I
I
F
F
F
Version: ELR-0633.D.2010.01.02
3C. Turn Cams(Q)
with a Phillips Head
G
Screwdriver until
locked onto the Metal
Dowels(J).
G
G
G
D
Q
J
4A. Insert Upper Center
Shelf(C) onto the slots in
the 4 Upper Dividers(F)
as shown, until fully
engaged.
4B. Two Adults
Suggested: Carefully
stand the unit upright.
I
4C. Slide the 5 Upper
I
Backs(I) into the grooves
between the Upper
Dividers(F) and into the
groove in the Lower Middle
Shelf(D) until fully inserted.
C
4D. Slide the Lower
Back(H) into the grooves
F between Lower Middle
Shelf(D) and Bottom
Shelf(E) until fully inserted.
D
H
E