ABB Ability Smart Sensor Gateway Installation Manual page 16

In computer, tablet or mobile phone, open the following web page while having an
Internet access:
http://www.bluetooth.tech/debugger/
Once the debug tool is loaded, connect the device used for configuration
(computer, tablet or mobile phone) to the WIFI network generated by the gateway.
If the gateway is connected to WIFI, then connect the configuration device to the
same WIFI network as the gateway is connected.
Type in the gateway's MAC and IP addresses to the fields Router MAC and Router
IP.
Press Start Scan.
Debug Tool now starts to list all Bluetooth devices within its range. For all scanned
devices the tool is showing the MAC address and RSSI value. Sometimes the name
is not available, but it is listed if known.
RSSI value can be roughly categorized to the following groups:
-
-
DOCUMENT ID
9AKK107046A4620
© Copyright 2020 ABB. All rights reserved.
Figure 11 Cassia Bluetooth Debug Tool
RSSI value between 0 and -70 is OK
RSSI value between -70 and -80 is weak, sensor might be read time to time
REV.
G
AB B ABI L IT Y ™ S M A RT S EN SO R G AT EWAY
DATE
April 2020
LANG. PAGE
EN 16/17