Yamaha AG-Stomp Owner's Manual page 7

G Pre-Amp Section
u
u MIC TYPE Select Switch (MIC TYPE)
Selects a microphone simulator type.
In the Utility Mode, it is used to select functions you
want to set such as Footswitch or MIDI Functions,
etc.
i BLEND Control (BLEND/STEREO)
Controls the volume balance between the guitar's
direct sound and the sound produced by the mic
simulator. (→ page 15)
When in the SHIFT mode, it is used to adjust the
mic simulator's stereo setting. (→ page 15)
o VOLUME
Controls the absolute sound volume of that set by
the Tone Controls.
* The VOLUME knob's setting is saved in memory.
G Effect Section
(Refer to the [Effect Functions and Parameters] section on page 21)
!3 LIMITER Button
Switches the Limiter ON (lamp lit) or OFF (lamp off).
i o
!3 !5
!4 !6 !7 !9
!0
!0 Tone Controls
(BASS, MIDDLE, TREBLE, PRESENCE)
Controls the level of the knob's related tone frequen-
cies.
When in the SHIFT mode, they set the variable cen-
ter frequency of the related Tone Control. (→ page
14)
!1 OUTPUT Level Control
Controls the level of the signal delivered from the
AG-Stomp's output jacks (OUTPUT, PHONES).
* The OUTPUT knob's setting is not saved in memory.
!2 SHIFT Button
The button is used to enter the SHIFT mode in which
the Mic Simulator's stereo setting and the Tone
Control's variable center frequency settings can be
made. (→ page 14 and 15)
!8 @2
@0 @1 @3
!4 LEVEL
Adjusts the depth of the Limiter's effect.
Turn to the right to increase the depth of the effect.
* When set to "0", the Limiter will produce no effect.
Nomenclature
!2
!1
7