Using The Ag-Stomp; I Connecting The Guitar - Yamaha AG-Stomp Owner's Manual

Using the AG-Stomp

First, connect your guitar to the AG-Stomp and try to get some sound.

I Connecting the Guitar

Before making any connections, make sure the AG-Stomp's power is off, set the AG-Stomp's OUTPUT
knob to "0" and the +9V SUPPLY switch to "OFF". Then connect the INPUT jack on the rear panel to the
guitar's output jack with any commercially available guitar cable (monaural ↔ monaural).
Never connect the guitar to the AG-Stomp with the supplied TRS phone cable when the Guitar Power Supply
function described below is not used. If the TRS phone cable is used and the +9V SUPPLY switch is switched
"ON", it may result in damage since a total of 18V will be supplied to the electric-acoustic guitar's built-in pre-
amplifier. Also, if the +9V SUPPLY switch is set to "OFF", the electric-acoustic's built-in pre-amplifier may func-
tion abnormally.
G Guitar Power Supply
Before supplying power to your guitar, make sure
that the guitar's pre-amplifier battery has been re-
placed with the dummy battery supplied with the
AG-Stomp. Leaving the 006P 9V battery in place will
result in the guitar's electronics receiving 18V of
power, causing damage.
The AG-Stomp is capable of supplying power to your elec-
tric-acoustic guitar's built-in pre-amplifier via the supplied
TRS phone cable. Power is supplied to the electric-acoustic
guitar when the AG-Stomp's power is switched ON.
This function is possible as long as your electric-acoustic
guitar meets the following conditions:
• The guitar uses a monaural output.
• The guitar uses a 006P 9V battery to supply power
to the guitar's built-in pre-amplifier.
• The power to the guitar's built-in pre-amplifier is
switched ON/OFF by connecting/disconnecting the
cable at the guitar's jack.
• The guitar's built-in electronics consume 10mA of
power, or less.
Replace the electric-
acoustic guitar's pre-
amplifier battery with the
dummy battery.
12
OFF ( )
[Setting]
1. Replace the electric/acoustic guitar's built-in pre-ampli-
2. Before making any connections, turn off the AG-Stomp's
3. Use the supplied TRS phone cable to connect the AG-
* When the AG-Stomp's power is ON, make sure that the MUTE
* Do not connect effectors, etc., between the AG-Stomp's IN-
Dummy Battery
Set the +9V SUPPLY
(supplied)
switch to the "ON"
position.
TRS Phone Cable (supplied)
fier battery with the dummy battery supplied with the
AG-Stomp.
power and make sure its OUTPUT knob is set to "0",
then set the +9V SUPPLY switch to "ON".
Stomp's INPUT jack to the output jack on your electric/
acoustic guitar.
switch on the AG-Stomp is held down when connecting/dis-
connecting the cable.
PUT jack and the electric-acoustic guitar's OUTPUT jack.
Power will not be supplied to the electric-acoustic guitar's
built-in pre-amplifier if the AG-Stomp and the electric-acoustic
guitar are not directly connected.
If the AG-Stomp's power
is ON, hold the MUTE
switch when making
connections.