Advertisement
Step 5. Install eFlux DC Flow Pumps
1. Unpack all components from eFlux DC Flow Pump box.
2. Determine installation method
The eFlux DC flow pump can be installed either submersible (internal) or inline (external). If using
in a submersible application, please use the inlet pump screen (included).
Submersible
3. Install Pump from eFlux DC Flow Pump box.
Submersible (internal) Installation
1. Thread pump filter screen to inlet of the pump.
2. Place O-ring inside the outlet barb fitting and quick
coupling. Thread barb fitting to pump and hand tighten.
3. Connect return hose (not included) by sliding over barb
fitting. Ensure hose is secured using a hose clamp (not
included).
Fill sump with water and check for water/air leaks.
Inline (external) Installation
1. Place o-ring inside the inlet barb fitting and quick coupling.
Thread barb fitting to pump inlet and tighten.
2. Place o-ring inside the outlet barb fitting and quick coupling.
Thread barb fitting to pump outlet and hand tighten.
3. Connect inlet hose (not included) by sliding over inlet barb
fitting. Ensure hose is secured by using a hose clamp (not
included.) Connect return hose to outlet barb fitting and
secure with clamp (not included).
Fill sump with water and check for water/air leaks.
4. Route DC pump cable to Power Center (larger model #4302 includes a DC pump extension
cable if required.) Plug DC pump into pump connection on DC manifold HUB (gray HUB.)
5. Adjust flow dial from 0-100% until desire flow rate is
achieved. Note: eFlux DC Flow pumps have a slow
start up/ramp to full speed. Allow pump to run 30
seconds to reach adjusted flow.
eFlux DC Flow Pump Installation
NOTE: READ ALL SAFETY INSTRUCTIONS
INCLUDED WITH EACH PRODUCT
LOOP® Marine Bundle Kit
External Inline
2
1
2
3
1
3
3
Connect to
4
Pump Input
eFlux DC Pump
Manifold HUB
Page 8
5
Adjust
Flow
Advertisement
