Advertisement
Step 3. Install Orbit Marine PRO IC LED Lights
1. Unpack LED light fixture box and remove all components and mounting hardware.
2. Mount light fixture on aquarium
Method 1: Adjustable docking legs
Slide the adjustable docking legs on the sides of the light fixtures to match the length of
your aquarium. Ensure the LED light cords are located on the side of the aquarium closest
to the Power Center installation. Set fixtures on aquarium and ensure docking legs fit snug
on edges of aquarium. Route lighting cables down to Power Center and organize
using the included velcro cable wraps.
Method 2: Adjustable tank arm mounts
Remove adjustable docking legs from each light by sliding legs outwards. The legs do
have a lock washer installed to prevent accidental pull out - therefore some force may
be required to remove them (give them a good pull.) Slide fixtures into light clips on each
arm bracket and adjust fixtures to optimal position. Route lighting cables down arms
using the included velcro cable wraps.
3. Route lighting cables behind stand and to
Power Center. Plug Orbit Marine IC LED lights
into lighting ports L1 and L2 on Orbit IC HUB.
4. Wrap any excess cable together and use
Power Center Tie Wrap to attach the excess
cable.
5. Press red POWER key on remote, turn LED
lighting ON.
6. Follow programming steps included with
Orbit Marine IC LED light to set the
LOOP® IC controller clock and begin
operation.
7. Wrap excess lighting cable to
power center using cable tie
mounts.
Orbit Marine IC PRO Installation
LOOP® Marine Bundle Kit
Light #2
L2
L1
Orbit IC HUB
Light #1
LOOP® IC
Controller
Page 6
Advertisement
