Advertisement
9. Plug the LOOP® IC controller into Port #1 on
the Orbit IC manifold HUB. If using the optional
remote IR sensor, plug into Port #2.
10. Use either the velcro tape included with the
LOOP® IC controller or install the controller
mounting bracket to the desired location
following the included instructions.
11. Unpack IR remote and remove clear tab
located at the bottom of the remote. Press
the red POWER key located in the top
right corner and ensure to ensure the
controller and remote are communicating.
12. Plug surge protector into a GFCI protected outlet and ensure drip loop is in place. CAUTION:
This product MUST be plugged into a GFCI protected outlet.
13. Toggle the surge protector POWER switch to the ON
position. Ensure the green indicator lights on all power
supplies illuminate and the LOOP® IC controller and
HUB indictor lights all turn On.
14. Install Power Center to stand wall by squeezing each
side of the Power Center inwards and aligning the
mounting slots with the wood mounting screws.
Power Center should flex out when released and be
mounted to stand wall. (See below)
Wood
+
Screw
Squeeze side panels slightly together
Wood
+
Screw
Power Center Installation
+
L2
L1
P3
P2
P1
+
eFlux DC Pump
Manifold HUB
POWER
!
"
#
11
Remove IR Remote clear tab
Press Power Key
Remove
clear tab
12
Surge Protector
14
Wood
Wood
Screw
Screw
Side panels will ex out when released
Wood
Wood
Screw
Screw
LOOP® Marine Bundle Kit
eFlux Wave Pump
Orbit Marine IC
Manifold HUB
Manifold HUB
P3
P1
L2
L1
P2
PORT #2
IR Sensor
(Optional)
Use only with GFCI
Protected AC Outlet
Plug surge protector
into GFCI AC outlet
GFCI Outlet
Ensure use of drip
loop for all cables
Install
Power Center
L2
L1
P3
P2
P1
9
Plug in controller
PORT #2
LOOP® IC
Controller
10
Install controller
AC Power
Wood
+
Screw
Wood
+
Screw
Page 4
Advertisement
