Rear Panel - Yamaha VL1 Owner's Manual

Y AMAHA MODEL VL1
AC INLET
POWER
ON / OFF
@2 POWER Switch
@1 AC Power Cord
Socket

Rear Panel

@ 1 AC Power Cord Socket
power cord into an AC outlet.
Getting Started page 22.
@ 2 POWER Switch
@ 3 OUTPUT L and R Jacks
the appropriate channels of a stereo sound system in order to appreciate the full quality of
the VL1 sound and effects.
Getting Started page 24.
@ 4 FOOT CONTROLLER 1 and 2 Jacks
of the VL1's controller parameters. One FC7 Foot Controller is supplied with the VL1,
and this should normally be plugged into the FOOT CONTROLLER 2 jack. The second
FC7 foot controller is optional.
Getting Started page 23.
@ 5 FOOT SWITCH 1 and 2 Jacks
these jacks for sustain, portamento, and other control functions.
Getting Started page 23.
@ 6 MIDI IN, OUT and THRU Connectors
device which is to control or transmit data to the VL1. The MIDI THRU connector
simply re-transmits the data received at the MIDI IN connector, allowing convenient
chaining of MIDI devices. The MIDI OUT connector transmits data corresponding to all
VL1 performance operations, or bulk data when one of the MIDI data transmission
functions are activated.
Getting Started page 24.
Getting Started The Controls & Connectors
MIDI
THRU OUT
@6 MIDI IN, OUT and
THRU Connectors
Be sure to plug the VL1's AC power cord into this socket before plugging the
Press to turn power ON or OFF.
These are the main stereo outputs from the VL1. Be sure to connect both outputs to
These jacks accept Yamaha FC7 Foot Controllers which can be used to control any
An optional Yamaha FC4 or FC5 footswitch can be connected to one or both of
The MIDI IN connector receives the data from an external sequencer or other MIDI
20
FOOT SWITCH FOOT CONTROLLER OUTPUT
2 1
IN 2 1 R
@3 OUTPUT L and R Jacks
@4 FOOT CONTROLLER 1 and 2 Jacks
@5 FOOT SWITCH 1 and 2 Jacks
L