Yamaha PortaTone PSR-510 Owner's Manual page 51

C
V
| | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | | |
"Gate Time" refers to the actual length of the note to be entered in rela-
tion to the note's step size — i.e. whether the note is staccato, legato, etc.
Gate times are specified as percentages of the total note length, as shown in
the list below.
Press the [GATE TIME] button and the current gate time will appear on
the MULTI DISPLAY. Then use the [+] and [–] buttons, the number but-
tons, the data dial, or the [GATE TIME] button itself to select the required
gate time (00 ... 10). The "08" gate time can be instantly selected by press-
ing the [+] and [–] buttons simultaneously.
Play the note on the keyboard corresponding to the pitch of the note you
want to enter, or a chord if you want to enter a chord. You can then press
the [STEP FWD (PLAY/STOP)] button while still holding the note or
chord as many times as necessary to extend the length of the note or chord
by the specified step size.
Rests can be entered by pressing only the [STEP FWD (PLAY/STOP)]
button immediately after specifying the required step size for the rest.
During step recording the leftmost digit on the MULTI DISPLAY repre-
sents the current beat, and the rightmost two digits represent the current
clock within the current beat (each beat consists of 96 clocks). The BEAT
indicator dots function in the same way as they do in the Auto Accompani-
ment mode.
In the STEP RECORD mode the [RESET] button functions as the
[STEP BWD] (step backward) button. You can use this button to step back-
ward through the recording by the currently specified step size while eras-
ing the data.
49