Advertisement
4
Installing the Hose Guides
Parts needed for this procedure:
1
Left hose guide
1
Right hose guide
2
Upper hose guide
2
Bracket
4
Hex-head flange bolt (3/8 x 1-1/4 inch)
4
Carriage bolt (1/4 x 3/4 inch)
4
Locknut (3/8 inch)
4
Locknut (1/4 inch)
6
Cable tie
Procedure
Install the lower hose guides on all machines.
Install the upper hose guides on the hybrid machines.
1.
Use the hex-head flange bolts (1/4 x 3/4 inch)
and locknuts (1/4 inch) to install the 2 upper
hose guides to the machine
Figure 22
1. Carriage bolt (1/4 x 3/4
inch)
2. Locknut (1/4 inch)
3. Upper hose guide
4. Cable tie
(Figure
22).
g263153
5. Left hose guide
6. Carriage bolt (3/8 x 1-1/4
inch)
7. Locknut (3/8 inch)
2.
Use the carriage bolts (3/8 x 1-1/4 inch) and
locknuts (3/8 inch) to install the left hose guide
(Figure
22).
3.
Use the carriage bolts (3/8 x 1-1/4 inch) and
locknuts (3/8 inch) to install the right hose guide
(not shown).
4.
Secure the hoses with the 6 cable ties.
5
Installing the Weights
Parts needed for this procedure:
1
Bumper
22
Weight
4
Bolt (1/2 x 5-1/4 inch)
4
Bolt (3/8 x 1-1/4 inch)
4
Locknut (1/2 inch)
4
Locknut (3/8 inch)
Procedure
2 people are needed to install the weights.
1.
Remove and discard the nuts and bolts securing
the rear bumper to the traction unit, and remove
and discard the bumper.
2.
Use the 4 short bolts (3/8 x 1-1/4 inch) and 4
locknuts (3/8 inch) to install the new bumper to
the rear of the machine
14
(Figure
23).
Advertisement
