Advertisement
17.
Install the sunshade onto the front and rear roof mounts with left and right roof mounts, hex-head flange
bolts (1/4 x 1 inch), sealing washers, and clips (Box A and B of
18.
Install the medium hole plugs into the unused holes in the left and right braces (Box C of
3
Installing the Wire Harness
Parts needed for this procedure:
1
Wire harness
Installing the Wire Harness on All
Machines
1.
Disconnect the battery; refer to the traction unit
Operator's Manual.
2.
Install the wire harness as follows and as shown
in
Figure 10
through
Note:
The power harness is required only if
your machine has optional powered accessories.
A.
Connect the positive terminal to the positive
post on the starter.
B.
Connect the negative terminal to the engine
ground.
C.
Ensure that the harness does not contact
any hot or moving parts, and secure it in
place with cable ties.
3.
Install the magnetic cable mounts as shown in
Figure
10.
Figure
20:
Figure
Figure 9
1. Magnetic cable mounts
10
9).
Figure
Figure 10
All models
g263108
9).
g219339
Advertisement
