Selection Of Location To Install The Product - Omnicomm LLS 20230 Installation Manual

Abbreviations and Symbols

Selection of Location to Install the Product

1) The product should be installed, depending on geometric shape of the tank, at the
locations shown in the figures (Figure 1, Figure 2, Figure 3). Product installation at
these locations ensures fuel level independence of vehicle inclination.
2) If the Product cannot be installed in any of places specified in Figures (Figure 1,
Figure 2, Figure 3), the installation place must be as close to any of the specified as
possible.
3) Product installation at the locations other than shown in the figures (Figure 1,
Figure 2, Figure 3), may cause fuel level dependence on vehicle inclination. For
example, for vehicles operating on the high-relief landscape this will mean either
overrated or underrated fuel level values.
Installation of two products in one fuel tank allows to significantly reducing fuel level
dependence on vehicle inclination. Two products should be installed at the locations
shown in the figures (Figure 4, Figure 5)
6