Yamaha PLG150-VL Owner's Manual page 33

4
Breath Control
............................................. Settings:BC (Breath Control), Exp (Expression)
Specifies the MIDI control change number to be used for breath control when breath control is
applied from a breath controller or WX-series Wind MIDI Controller. When "BC" is selected
control change number "02" (breath control) is used for breath control. When "Exp" is selected
control change number "11" (expression) is used for breath control.
• This parameter is also available for the breath controller data transmitted from a device other than the WX-
series.
• This parameter is effective only when "BC/WX" is selected from Breath Mode.
5
Breath Curve
.............................................................................................Settings: -16 ... +16
Determines the relationship between breath control data received from a breath controller, WX-
series Wind MIDI Controller (via the BT7 and MIDI IN connector), and the actual amount of
breath variation applied. Minus settings result in a large breath variation with a relatively small
amount of breath pressure applied to the controller, while plus settings required a greater range of
input breath control values to produce the same degree of breath variation.
• This parameter is also available for the breath controller data transmitted from the device other than WX-
series.
• The settings made here is effective only when "BC/WX" is selected from Breath Mode.
• Connection Between WX-series and "mother" tone generator/sound card
WX5
WX IN
MIDI OUT
When you use a sound card built into PC...
To control PLG150-VL using WX-series Wind Controller, select "SW1000 #1 Synthesizer" for the
MIDI Thru setting in the System Setup dialog of the "XGworks lite."
BT7
MIDI
OUT
VL System Parameters
CS6x
MIDI
MU128
IN
33