Cleaning - Philips BlueTouch PR3092 User Manual

1 2 3 4
2 Press the mode button for 5 seconds.
First the first two rows of LEDs light up briefly. When they go out,
,
the third and fourth row light up briefly. When the third and fourth
row go out, the fifth and sixth row light up briefly. When the fifth and
sixth row go out, the seventh and eighth row light up briefly.
After this the BlueTouch Pain Relief Patch is reset and works
,
normally again.
Battery level signals
When you press the mode button, the charging light shows the battery
status. The charging light goes out when the sensor senses skin contact or
when the device is switched off.
1 When the batteries contain enough energy for two or more
treatments, the charging light is solid green.
You can select a mode and start treatment.
,
2 When the batteries contain just enough energy for one treatment,
the charging light is solid orange.
You can select a mode and complete just one treatment.
,
3 When the batteries are empty, the charging light turns solid red for
5 seconds and the BlueTouch Pain Relief Patch produces 3 beeps when
you press the mode button.
You cannot select any mode. You have to charge the batteries before
,
you can start a treatment.

Cleaning

Do not immerse the BlueTouch Pain Relief Patch in water or rinse it
under the tap.
Always remove the BlueTouch Pain Relief Patch from the strap before
you put the strap in the washing machine to clean it.
1 Clean the BlueTouch Pain Relief Patch with a damp cloth.
Caution: Clean the infrared sensor with a damp cloth after each
treatment to ensure it continues to function properly.
2 The BlueTouch Pain Relief straps can be washed in the washing
machine.
Caution: To prevent damage to the BlueTouch Pain Relief straps and
other clothes in the washing machine, wash the straps in a fine-mesh
washing bag.
Note: Use a gentle cycle and a temperature of 30°C maximum.
Dry the BlueTouch Pain Relief straps on the air and not in the tumble dryer.
Do not iron the straps.
ENGLISH
23