BenQ AQ COLOR SW Series User Manual page 19

2. Connect the PC video cable
To Connect the HDMI Cable
Connect the plug of the HDMI cable to the HDMI port
on the monitor. Connect the other end of the cable to
the HDMI port of a digital output device.
To Connect the DP Cable
Connect the plug of the DP cable to the monitor video
socket. Connect the other end of the cable to the
computer video socket.
After the monitor and the computer are powered on, if the
image is not displayed, disconnect the DP cable. Connect the
monitor to any video source other than DP first. Go to
and
System DisplayPort
and change the setting from
done, unplug the current video cable and re-connect the DP
cable. To go to the OSD menu, see
page 45.
To Connect the USB-C™ Cable
Connect the plug of the supplied USB-C™ cable to the
USB-C™ port on the monitor. Connect the other end
of the cable to the USB-C™ port of a laptop. It allows
signal, audio, and data transmission from the laptop to
the monitor.
(SW271) The USB-C™ port on the monitor transfers data
only and does not support power delivery to the laptop.
Additional power supply to the connected laptop is
required.
(SW270C) The USB-C™ port on the monitor supports
power delivery. See Power delivery of USB-C™ port on
your monitor (SW270C only) on page 16
information. If a USB-C™ cable is not included in the
product package, make sure the purchased cable is certified
by USB-IF and is full-featured, with power delivery and video
/ audio / data transfer functions.
Due to USB-C™ technology limitation, the USB
transmission speed is determined only by the selected
refresh rate. See USB-C Configuration on page 65
Options for data transfer via USB-C™ (SW271 / SW270C
only) on page 67 for more information.
on the OSD menu of the monitor
to . Once the setting is
1.4 1.1
Basic menu operation on
for more
and
How to assemble your monitor hardware
Either
Or
Or
19