Yamaha Clavinova CLP-100 Owner's Manual page 89

Yamaha musical instrument owner's manual
Hide thumbs Also See for Clavinova CLP-100:
Table of Contents

Advertisement

5.
Connect the speaker cord.
5-1
Remove the twist tie attaching the speaker cord.
5-2
Insert the speaker cord plug into the connector
so that the protruding tab on the plug faces
toward right when viewed from the rear.
5-2
6.
Connect the pedal cord.
6-1
Insert the pedal cord plug into the [PEDAL] con-
nector.
6-2
Attach the cord holders to the instrument as
shown, then clip the cord into the holders. At this
time, be careful not to allow too much slack in
the pedal cord between the plug and cord holder.
6-1
7.
Attach C.
7-1
Place on D, the stopper-wood in the bottom
corners of C, then attach the top of C.
7-2
Secure upper right and left of C using two thin
screws (4 x 14 mm).
7-3
Secure upper center and bottom of C using five
tapping screws (4 x 20 mm).
7-1
D
C
7-3
6-2
E
7-2
C
CLP-S308/S306: Keyboard Stand Assembly
8.
Connect the power cord.
8-1
For models that feature a voltage selector: Set the
voltage selector to an appropriate voltage.
Voltage Selector
Before connecting the AC power cord, check the setting
of the voltage selector which is provided in some
areas. To set the selector for 110V, 127V, 220V or 240V
main voltages, use a "minus" screwdriver to rotate the
selector dial so that the correct voltage for your region
appears next to the pointer on the panel. The voltage
selector is set at 240V when the unit is initially
shipped. After the proper voltage has been selected,
connect the AC power cord to the AC IN and an AC
wall outlet. A plug adaptor may be also provided in
some areas to match the pin configuration of the AC
wall outlets in your area.
WARNING
An improper voltage setting can cause serious damage to the
Clavinova or result in improper operation.
8-2
Insert the AC power cord plug into the [AC IN]
connector.
9.
Set the adjuster to secure the pedals.
Rotate the adjuster until the pedal box comes in
firm contact with the floor surface.
10.
Attach the headphone hanger.
Use the included two screws (4 x 10 mm) to
attach the hanger as shown in the illustration.
CLP-370/340/330, CLP-S308/S306 Owner's Manual
89

Advertisement

Table of Contents
loading

Table of Contents